Coveralls, work boots, hi-vis jackets, and utility shirts issued to European military mechanics, deck crews, and ground personnel. Heavier fabric, reinforced seams, tool-sized pockets — built for a motor pool, priced like surplus.
Military work clothing was never designed to be fashionable. It was designed to survive a mechanic's bay, a ship's engine room, and a motor pool, then get laundered a hundred times and go back out. That's why genuine issued work jackets, coveralls, and work shirts hold up where consumer workwear gives out: heavier fabric weights, reinforced stress points, real bar-tacking, and pockets sized for tools rather than phones.
This collection pulls the working-uniform side of the surplus catalog into one place: Dutch and British coveralls, Austrian and German field boots, hi-vis jackets from British police and border patrol, and the shirts that go under them. Prices run from a $5 Dutch Navy work shirt to Italian Gore-Tex steel-toe safety boots. Most items are genuine issued surplus, so expect honest wear — minor shade variation between lots, occasional unit markings, and the odd repair. Sizing follows European military charts, which run trimmer than US casual. Check the size chart on each listing before ordering.
Built for work, priced like surplus.
Most items in this category are genuine issued surplus, meaning they were worn in service before being sorted and graded. Expect minor shade variation, possible unit stamps or name tags, and light wear. Any item listed as unissued is noted on its product page.
European military garments are cut with less ease than US casual clothing, and work layers are often meant to go over a base layer. Measure your chest and waist and compare against the chart on each listing rather than ordering by your usual US size.
Both. These garments were issued to mechanics, deck crews, and ground personnel and were built to be worn hard. Fabric weights and reinforcement points generally exceed what's found in comparably priced consumer workwear.
Not unless the specific listing states it. Cotton and cotton-blend work garments are not certified FR and should not be substituted for rated FR clothing in welding, electrical, or hot-work environments.
Machine wash cold with a mild detergent and hang dry. Cotton twill work garments can shrink in a hot dryer, and used surplus has already been through many industrial launderings, so gentler care extends its life considerably.
European hi-vis garments are typically manufactured to EN ISO 20471 or the earlier EN 471, but issued surplus has been through service laundering, and retroreflective tape loses performance over time. Treat these as high-visibility workwear rather than as certified PPE for a regulated site, and verify against your own jobsite requirements before relying on them.
Yes. The Italian Jolly 6508/GA Blackstorm is an unissued Gore-Tex boot with a steel toe. The remaining footwear in this category is issued military field and mountain boots, which are built for durability but are not safety-toe rated.